INSTALLATION AND HANDLING
The machine can be handled by a single person. It is recommended that the appliance be
placed on a table or worktop for more comfortable use with the controls facing you
(recommended height: 90 cm, to be adapted as required for the user).
ELECTRICAL CONNECTION:
• The appliance's power supply is available in two single phase voltages:
- 110-120 V, 50/60 Hz
- 220-240 V, 50/60 Hz
Line protection: the appliance must be connected to a standard 2 pole + earth socket. The
set-up must be fitted with a differential circuit breaker and a 16A fuse. The appliance
must be earthed.
TAKE CARE:
• Before connecting the machine, check that the mains electrical voltage is the
same as the voltage for your appliance. Its value is shown:
either on the identification plate under the machine.
or on the identification plate on the last page of this manual.
• If the power cable is damaged, it should be replaced with a special unit
available from SANTOS or a SANTOS-approved dealer.
TAKE CARE: Check that the On / Off switch (6) is in the 0 position before connecting the
power cable plug to your mains electric power socket.
To Next Page
Loading...
