Sanuvox SRMax - Important Safety Instructions & Warranty

3
WARNING
Before installing or performing maintenance on the unit, TURN OFF and disconnect unit from power source.
Electrical shock may cause personal injuries or possibly death.
Never expose eyes or skin to ultraviolet light from any source. e UV purier MUST be DISCONNECTED
from power source before performing maintenance of service. Personal injury may result.
Do not touch lamp glass without gloves. Reduced performance of lamp may result. Clean lamp aer handling.
e UV lamp contains a small quantity of mercury. If a lamp breaks, clean and dispose of with care.
Use only specied replacement lamps with your unit. Use of an incorrect lamp can result in damage
to the unit and/or lamp and will also void the warranty.
When applicable local regulations comprises more restrictive installation and/or certication requirements,
the aforementioned requirements prevail on those of this document and the installer agrees to conform to these
at his own expense.
When performing installation, servicing or cleaning the UV purier, it is recommended to wear safety glasses
and gloves.
IMPORTANT SAFETY INSTRUCTIONS
NOTICE
UV lamp can be disposed / recycled aer use as any other uorescent lamp.
Contact and follow your local and national authorities’ specic instructions.
Component Warranty
UV lamp 3 years
Ballast 3 years
Electronics (circuit board) 3 years
WARRANTY
e warranty applicable to the dierent components included in your purchase are as per the table below:
Make sure to keep a copy of your proof of purchase in order for the warranty to be valid.