Operation with the Remote
Control Unit
1. Automatic Operation
NOTE
Check that the circuit breaker on the power panel is turned on and that the
operation selector of the indoor unit is in the ON position.
Once the
mode is selected and the unit is preset by following the steps
below, you can have the air conditioner automatically bring the room to the
desired temperature simply by pressing the ON/OFF operation button.
STEP 1 Press the MODE selector to select .
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation button again.
NOTE
•
To change the temperature setting, press the temperature setting
buttons and change the setting to the desired temperature.
•
The temperature setting changes by two degrees each time one of the
TEMP. buttons is pressed.
SET TEMP.
1HR.
TIMER
ON
OFF
TEMP.
FAN SPEED
MODE
ON OFF
SET
CANCEL
NIGHT
SETBACK
FLAP
STEP 2
STEP 1
12 OI-202-14EG
oi202000
To Next Page
Loading...
Need help?
General
