Sanyo CHDZ07263 - Emergency Operation

2 - 12
Remote Control Functions
2. Wireless Remote Controller
1
2
3
4
5
6
7
8
2-6. Emergency Operation
In any of the following events, use the Emergency operation button to operate the air
conditioner on a makeshift basis.
• When there is no charge remaining in the wireless remote control unit's batteries
• When the wireless remote control unit has failed
• When the wireless remote control unit has been lost or misplaced
X, XM types Initiate operation using the Emergency operation button in the operation area of the indoor unit.
A, T types Initiate operation using the Emergency operation button in the signal receiver on the indoor unit.
K type Initiate operation using the Emergency operation button in the operation area of the indoor unit.
• TEST is used to initiate a trial run when the air conditioner is first installed. It is not used
under normal circumstances.
• To restart the wireless remote control unit's operation, the ON/OFF operation switch must
be set to ON without fail. If it is kept at the OFF setting, the signals from the wireless remote
control unit will not be accepted.
Operation
Press the Emergency operation button.
The air conditioner initiates a cooling operation when its operation is started up at
a room temperature of 75°F or above.
Conversely, it initiates a heating operation when its operation is started up at a
room temperature below 75°F.
Shutdown
Press the Emergency operation button once more.
Operation
Press the Emergency operation button.
The air conditioner initiates a cooling operation when its operation is started up at
a room temperature of 75°F or above.
Conversely, it initiates a heating operation when its operation is started up at a
room temperature below 75°F.
Shutdown
Press the Emergency operation button once more.
Operation
Set the ON/OFF operation switch to “OFF” first.
Then set it to “ON. ”
If a heat pump is used, the air conditioner initiates a cooling operation when its
operation is started up at a room temperature of 75°F or above or it initiates
a heating operation when its operation is started up at a room temperature below
75°F.
Shutdown
Set the ON/OFF operation switch to “OFF.”
NOTE
SM830183-003WAYECO-i.indb12SM830183-003WAYECO-i.indb12 2010/03/0311:14:342010/03/0311:14:34