Sanyo CHDZ07263 - Page 44

2 - 24
Remote Control Functions
3. Timer Remote Controller
1
2
3
4
5
6
7
8
4. Set the program pattern.
(program step 3)
There are 4 program patterns.
Pressing
/ repeats the following display patterns.
Pattern 1
The indoor unit starts operation at the programmed
time.
Pattern 2
The indoor unit stops operation at the programmed
time.
Pattern 3
The indoor unit starts operation at the programmed
time and changes the temperature settings.
Press
/ to change the temperature setting.
Pattern 4
The indoor unit changes the temperature setting at
the programmed time.
Press
/ to change the temperature setting.
Pattern 1
Pattern 2
Pattern 3
Pattern 4
Select the program pattern and press
. The program timer setting is confi rmed and the unit enters the confi rmation mode .
NOTE
If you press during the setting, it returns to the program confi rmation mode.
If there is no operation made for 3 minutes during the setting, it returns to the normal mode.
In this case, all the settings in progress will be invalid.
SM830183-003WAYECO-i.indb24SM830183-003WAYECO-i.indb24 2010/03/0311:14:412010/03/0311:14:41