Sanyo CHDZ07263 - Page 45

2 - 25
Remote Control Functions
3. Timer Remote Controller
1
2
3
4
5
6
7
8
Deleting the Program Timer
To delete the program timer setting, follow the steps below.
1. Press
to enter the program confi rmation mode.
2. Press
/ to select the day of the program you want to
delete.
3. Press
/ to select a TIMER No. (from 1 to 6).
4. Press
to display the program setting mode .
5. Press
to delete the program.
NOTE
After deleting, the unit returns to the program confi rmation mode .
If you press during the setting, the unit returns to the program
confi rmation mode.
If there is no operation made for 3 minutes during the setting, the unit
returns to the normal mode.
Invalidating Program Timer
If you want to adjourn the program operation for more than 1 week, you can
invalidate all the timer settings.
Once the timer settings are invalidated, the program will not be operated until the invalidation is cancelled.
<<How to invalidate the program timer>>
Press and hold for more than 2 seconds.
is displayed and the programs will be invalidated from the next one.
<<How to cancel the program timer invalidation>>
Press and hold for more than 2 seconds.
disappears and the programs will be validated from the next one.
If Power Failure Occurred
If the power recovers in a short time period, the program after the recovered time will be valid.
If the power recovered more than 1 hour after the failure, the present time information will be lost. In this case, the program will
not be operated.
43512
SM830183-003WAYECO-i.indb25SM830183-003WAYECO-i.indb25 2010/03/0311:14:412010/03/0311:14:41