REMOTE CONTROL
Switch off TV and external equipment before con-
necting cables. (Cables are not supplied.)
1
Connect a DVD Player or other equipment’s
Component Video Out to the TV Component
Video In (Y-Pb-Pr) Jacks.
2
Connect the DVD Player’s Audio Out to the TV
Component L/R Jacks.
3
Press POWER to turn on the TV. Turn on external
equipment also.
4
Press the INPUT key to select COMPONENT3.
DVD PLAYER
USING THE COMPONENT AUDIO/VIDEO INPUT JACKS
TV COMPONENT3
JACKS
TV BACK
1
A solid Blue screen with COMPONENT3 displayed means
that the Video mode is selected, but no signal is being
detected at the Component jacks. Check connection, and
turn on external equipment.
Press the INPUT key after connecting cables to access
the A/V Inputs. There is NO need to tune to a blank
channel.
What you will need
for connections:
1
Component Video
Cable – 1
2 Audio Cable – 1
8
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
2
3
4
CONNECTING A DVD PLAYER OR OTHER EQUIPMENT
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you
must
run All Channel Search twice before
you can select the AV inputs.
To Next Page
Loading...
