Switch off TV and external equipment before con-
necting cables. (Cables are not supplied.)
1
Connect VCR, DVD Player, or other equipment’s
Audio Video Out to the TV Audio Video Input.
For Mono VCR (Single Audio Jack) connect
VCR Audio Out to TV Audio (L) Input.
Optional (
11
/
22
)
Connect DVD Player or other equipment’s
S-Video Out to the TV S-Video In Jack.
Using the S-Video jack overrides the Video (AV1)
jack.
Connect DVD Player or other equipment’s Audio
Out to the TV Audio In Jacks.
2
Press POWER to turn on the TV. Turn on exter-
nal equipment also.
3
Press the INPUT key to select VIDEO1 or
VIDEO2.
USING THE AUDIO/VIDEO INPUT JACKS
BACK VIEW OF VCR
TV AV INPUT JACKS
DVD PLAYER
Press the INPUT key after connecting cables to access the
A / V Inputs. There is NO need to tune to a blank channel.
Make sure all cable connectors are fully seated on jacks.
Always match A/V cables according to the colors; red for
right audio, white for left audio and yellow for video.
A solid Blue screen with the word VIDEO1 or VIDEO2,
displayed means that the Video mode is selected, but
no signal is being detected at the Video jacks. Check
connections, turn on external equipment.
What you will need
for connections:
1
A/V Cable – 1
OPTIONAL CONNECTION
1
S-Video Cable – 1
2
Audio Cable – 1
9
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
11
22
1
CONNECTING A VCR OR DVD PLAYER
IMPORTANT NOTE FOR
MONITOR USE:
If you did not connect an
antenna, you
must
run All
Channel Search twice
before you can select the
AV inputs.
REMOTE CONTROL
3
2
To Next Page
Loading...
