MECHANISM REMOVAL (CD)
(4) Lubricating the base lever
(5) Lu&icating the pickup sled gear and clutch gear
..
.
.,
Apply grease (FLOIL G-474 B}tothe, ~< area in the figure.
1) Apply grease (FLOIL G-474B) around the entire circumference
of the lower gear of the pickup sled gear (CM12), as shown
in the figure ( ;jj$ area).
2) Apply grease (G-333) around the entire circumference of the
outer clutch gear (CM9).
I
CEM~Dl;5E
3) Apply grease (FLOIL G-474B) to the ~~ Part of the outer
clutch gear (CM9) where it makes contact with the inner
clutch gear (CM8).
PICKUP SLED GEAR
m
8
Q
& –~M12
,<;., ,..
:,. .
:L.
FLOIL
(G-474B)
CLUTCH’ INNER GEAR”’ $-
mij+jii .:. ._ .:
m
CM8 J?
I
,+~> , @
. .
4 &-
. CLUTCH cM9 .-.
.. .. .. fi#. *rll CF. m -
%
““ -<
,-.-,.,
... .
,,. ...
rJL
:R(35- l\ //l-
I
‘T’, ,( 1-
..
,>J&’
CEMEDINE
J‘“-”””
<
Uulcn Ucfin
,’ .’....
,J. .
lkL
-,,
., _.. ..-. ——
.
“ p“?”
—.........—-.-
.
.....,
,...
__.-aq~‘
-.
,..
I ,, \\-- ”----”--- ‘-- “-- “-
,:
. . . .
. .
T
\\
.
,.
,.. -.
‘.
,. .
:.
-.
(6) Arranging and securing the leads
1) As shown in the ~gure, set the pickup (CM52) at a position on the innermost circumference of the compact disc, and pass the
leads from the pickup (CM52) and spindle motor (CM4B) through pin (a) of the chassis (CM39). Arrange the leads from the load-
ingkled motor (CM38) and sensor switch (micro switch) (CM26) by passing them through point (b) in the chassis (CM39). After
securing the leads with the lug (CM41), check that the pickup (CM52) moves smoothly without the leads interfering with its
movement.
2) if no problems arise in the @ check, secure the points shown in the figure usin9 a bonding a9ent (Cemedine X575).
.....
..-
lzzl FLOIL(G-474B)
TO CN101 COPCB
-BE NOT SLACK
m
x
o
.,
. .
NOTE THE LUG PORTION
-6-
CUk.HION
To Next Page
Loading...
Need help?
General
