Sanyo DC-D5 - LISTENING TO THE RADIO; Station Memory and Selection; RECORDING FROM THE TUNER OR PHONO INPUT

SERVICE MODE
\ ‘
Specifications
,.
To enter any service mode, first simulta eously press the CD MEMORY and BAND (TUNER) keys on the unit. This accesses the ser-
7
vice mode entry state. Now press one ofj~he buttons on the unit to enter a service mode. As the service mode entry state is dis-
continued after 1 second elapses, the system will enter a service mode only if the next key is pressed within one second.
I. Checking the key input signal connections
-
Enter this mode by pressing the ME MORY(TUNER) key during the service mode entry state.
. The entire LCD goes out once this mode is entered.
. [n this mode, as keys on the unit are pressed segments on the LCD corresponding to each key on a one-to-one basis come on
(i.e. the lit portions gradually increase). (Refer to Table 1.)
. Press the FM MODE (TUNER) key to exit this mode and return to the normal mode.
I
KEY
I DISPLAY I
I
KEY
I DISPLAY II
KEY
I DISPLAY I
1
BAND
DIGIT 1 : ~
MEMORY
DIGIT 2 :
!
] FM MODE
I@
I
I REPEAT
I REPEAT II POWER
IDIGIT 7:+ I
PIAYI PAUSE
-
RANDOM RANDOM
STOP TIME EDIT
EDIT
TUNING UP
DIGIT 4: ~
SKIP/SEARCH Ml
FADE
..-
TUNING DOWN
DIGIT 5: ~ SKIP/SEARCH M TRACK
PRESET UP
SIDE A - -.
OPEN/CLOSE
INTRO
,,
CD MEMORY
PROG. PRESET DOWN SIDE B
..
@ :
Releases the key checking mode and returns the set to the normal mode.
TABLE I : CORRESPONDING KEYS AND DISPLAYS IN THE KEY iHECKING MODE
INTRO
RANDOM
m
REPEAT
12
f /~q /
~
‘GJ4-l
TRACT
STEREO
34567
FI’+1’12//-//-/,/-//-/ kHz SIDEA
L~AM-/ /“I~!/:/-//-/
~HZ WEB
AUTO MONO FADETIME EDIT
D
... .
FIGURE 1 : LCD ( LIQUID CRYSTAL DISPLAY)
2. Checking LCD connections
.
Enter this mode by pressing the REPEAT key during the service mode entry state. (See note.)
. The entire LCD goes out once this mode is entered.
. In this mode, all segment of the LCD lights each time the REPEAT key is pressed.
. Press the FM MODE key to exit this mode and return to the normal mode.
3. CD tracking balance adjusting mode
.
Enter this mode by pressing the PLAYIPAUSE key during the service mode entry state.
. If the power is off when this mode is entered, the power automatically comes on.
. In this mode, the tracking balance adjustment state (tracking is off) is automatically entered after the tray is completely
closed.
-7-