Sanyo DC-D5 - Page 10

7. Load a C-46 cassette into deck B to record side A.
8. Press the REC button.
9. Press the PLAY/PAUSE switch.
- The total play time for side A is displayed.
- The total play time for side B is displayed.
Recording starts automatically from the first programmed track.
a
PROG. TRACK
5 0.01 EDIT SIDE A
b
10. Follow steps 5-6 of “Time edit recording”.
Backward skip edit recording
This type of recording is the easiest to perform and the tape length setting is not required.
Example:
The track 4 will be interrupted.
SIDE A
i
1
II
2
II
3][4
H
H
)
Manual reverse
8~]711 6
5 4
7
Record from the beginning of a track.
SIDE B
The track 8 will be interrupted.
1,
2.
3,
4.
Press the EDIT switch until “C -- -“ appears.
5. Follow steps 5-6 of “Time edit recording”.
Load a cassette.
Press the REC button.
When the tape stops automatically at the end of side B, CD play also
Press the PIAY/PAUSE switch. Recording starts on side A.
stops,
MANUAL RECORDING
1, Set the FUNCTION switch to CD.
3, Press the REC button. (Deck B enters the record pause mode.)
2. Load a disc and cassette.
4, Press the PIAY/PAUSE switch. Recording starts.
For programmed recording, programme the material in advance
(as described under “PROGRAMMED PL4Y”).
TAPE DUBBING (DECK A to DECK B)
1. Load the playback cassette into deck A and a blank cassette into deck
B.
2. Set the FUNCTION switch to TAPE.
3. Set the cassette in deck A to the point where recording will begin.
4. Select the dubbing speed with the DUBBING/BEAT CANCEL switch.
NOR:
For dubbing while monitoring at normal speed.
HIGH:
For dubbing the tape at high speed (twice normal speed).
5. Press the PAUSE button of deck B.
6. Press the REC button of deck B.
7. Press the PLAY button of deck A to start dubbing.
8. To stop dubbing, press both STOP/EJECT buttons.
Automatic stop during dubbing
When deck A tape is longer than deck B tape:
When deck B stops automatically, deck A continues playback mor-
at normal speed.
When deck B tape is longer than deck A tape:
When deck A stops automatically, deck B erases the tape to the end.
Do not change the dubbing speed during the dubbing operation.
-9-