Backward skip edit recording
The track 3 will be interrupted.
SIDE A
i
1
2
1
3
i
II
~J
Auto reverse
5
4
3
I
Record from the beginning of a track. SIDE B
The track 5 will be interrupted.
This type of recording is the easiest to perform and the tape length setting
is not required.
Example:
Press the EDIT switch once.
The EDIT indicator lights and “- -“ appears on the CD display.
Recording starts automatically on side A with track 1. The PLAY and
SIDE A indicators light and “1” appears.
When the tape automatically reverses, the SIDE A indicator goes out and
SIDE B lights and recording continues from the beginning of thelasttrack
played.
When the tape automatically stops, the player will continue playing mode.
If the disc playing time is shorter than the specified time on the side B,
the player automatically stops after the end of playing and the deck
enters the record pause mode.
The edit mode remains operational when recording ends. Press the STOP
switch of the CD player to cancel edit recording.
Time edit recording
When the track 3 is not recordable within the specified time, select any
recordable track after track 4.
Unrecorded blank
SIDE A
1
1
2
6 ;.;
.........
8$
~>
Auto reverse
,.,.,.,.,.,.,.,............ ..........,.:.:
7$
4
3
I
I
SIDE B
Unrecorded blank When the track 5 is not recordable within the specified time, select any
recordable track after track 6.
Tracks are automatically programmed by separating them for the sides A
After this, the CD display and CD operation indicator(s) show as:
and B of a tape so that they can be recorded within the specified time.
“1 “ — “2” — “6”
EDIT, PROGRAM, SIDE A
(Tracks are edited so that the remaining tape time becomes to be
Side A: Tracks 1, 2, and 6 are recorded.
minimum.) “3”- “4” — “7” — “8”
EDIT, PROGRAM, SIDE B
Side B: Tracks 3, 4, 7 and 8 are recorded.
Example:
Recording of side A starts automatically.
To record onto a 48-minute tape.
,, ,,
1 PLAY, EDIT, PROGRAM, SIDE A
1.
2.
Press the EDIT switch, The EDIT indicator lights.
When the tracks to be recorded onto side A have been played, the
Press the EDIT switch within 3 seconds until “46” appears on the
display.
player enters the pause mode at the beginning of the first track to be
recorded onto side B.
- Each time the switch is pressed, the tape length display changes
“3”
PLAY (bTnks), EDIT, PROGFWM, SIDE B
in the following sequence: When the tape automatically reverses, recording of side B start._
46~60~90bo_. .
automatically.
“3”
PIAY, EDIT, PROGRAM, SIDE B
Programme edit recording
Unrecorded blank
SIDE A
.:,
,. .,
5
,,
2 3
::...:.
....,.,
,.,.,
:,:
‘~J
Auto reverse
4
;::;
1
:,:.
I
Unrecorded blank
Tracks are recorded in desired order within the specified tape length. 3,
Example: 4.
To record onto a 46-minute tape.
1. Press the EDIT switch. The EDIT indicator lights.
5.
2. Press the EDIT switch within 3 seconds until “46” appears.
SIDE B
Press the MEMORY switch within 3 seconds. The PROGRAM and
SIDE A indicators light and “1” blinks.
Select thetrackto be recorded by using the O- 9 and +10 switches on
the remote control. The selected track number blinks.
Press the MEMORY switch. The selected track number remains lit.
-11-
To Next Page
Loading...
