24
2. Confirmation of Memory.
(Example) When programme No.3 is programmed as:
1st input: Max power 30 sec. 2nd input: Power Level 5 1min. 3rd input: Power Level 2 2min.
Operation Display window
1
2
3
4
5
¡Touch number “3”.
¡Touch number “3” again.
¡Touch number “3” again.
¡Touch key.
¡“0” appears in the display.
¡Programmed No.3.
¡Input power Level bar “10”.
¡Input time 30 sec. (1st stage)
¡Programmed No.3.
¡Input power Level bar “5”.
¡Input time 1 min. (2nd stage)
¡Programmed No.3.
¡Input power Level bar “2”.
¡Input time 2 min. (3rd stage)
¡“0” appears in the display.
¡Open the door.
Note:
1. Touch CLEAR key after confirming the contents of the unit’s memory.
2. If nothing is in the memory, the programme selection key indicator will flash.
3. If you wish to change a programme memory, touch MEMORY key twice and then input again as shown in pages 22 – 23.
To Next Page
Loading...
