Sanyo FWBP507FF - Connections; Connecting to a TV

EN 11
4. CONNECTIONS
4.1. Connection to a TV
C HDMI connection (supports up to 1080i
(
*
1)
, 1080p
(
*
2)
, 1080p/24
(
*
3)
resolution.)
HDMI IN
HDMI OUT
Your TV
HDMI cable
(not included)
(*1) 1080i: Outputs video data with a frame rate of 30 frames per second.
(*2) 1080p: Outputs video data with a frame rate of 60 frames per second.
(*3) 1080p/24: Outputs video data with a frame rate of 24 frames per second. To enable 1080p/24 output, set
“Resolution” to “Auto” or “1080p”, and set “HDMI1080p 24Hz” to “On”.
• Do not tilt the connector when inserting it into the HDMI jack, and make sure the shapes of the jack and the
connector are matched.
• When connected to an HDCP incompatible display device, the picture will not be displayed properly.
• Use an HDMI cable with the HDMI logo (a certified HDMI cable) for this connection. High Speed HDMI cable (also
known as HDMI category 2 cable) is recommended for better compatibility.
NoteD
• If the TV receives no audio / video signal after properly connecting the unit and the TV with an HDMI cable, it may
be the TV. Please refer to the TV’s user’s manual.
• If the TV receives no audio signal after properly connecting the unit and the TV with an HDMI cable, make sure the
TV input is not an HDMI-DVI Input terminal.