Sanyo FWBP507FF - HDMI Video Resolution

EN 38
10.2. HDMI video resolution
HOME A “Setup” A “ ” A “TV” A “Resolution”
Sets the resolution of the video signal output from the HDMI OUT jack.
C Set up resolution
1. Use [ ] to select “Setup” in the home menu, then press [OK].
2. Use [
] to select “ ”, then press [OK].
3. Use [
] to select “TV”, then press [OK].
4. Use [
] to select “Resolution”, then press [OK].
5. Use [
] to select your desired Setting, then press [OK]. On the confirmation screen, use [ ] to select
“OK”, then press [OK].
6. Press [HOME] to exit.
C Set up HDMI 1080p/24Hz
1. Follow steps 1 to 3 in “Set up resolution” above on this page.
2. Use [
] to select “HDMI 1080p 24Hz”, then press [OK].
3. Use [
] to select “On” or “Off”, then press [OK].
4. Press [HOME] to exit.
You can select the desired “Resolution” among the settings listed below: “Auto”, “48 0p”, “720p”, “1080i”, “1080p”.
Actual output resolution:
Setting in
“Resolution”
Setting in
“HDMI 1080p
24Hz”
Source
480i/60 480p/60 720p/60 1080i/60 1080p/60 1080p/24*
Auto
On
The highest resolution supported by your display device will automatically
be in effect.
* Images will be output in 1080p/24 when the connected device supports
1080p/24.
Off
The highest resolution supported by your display device will automatically
be in effect.
* Images will be output in 1080p/60 even if the connected device supports
1080p/24.
480p
On
480p/60
Off
720p
On
720p/60
Off
1080i
On
1080i/60
Off
1080p
On
1080p/60
* Images will be output in 1080p/24 when the connected device supports
1080p/24.
Off
1080p/60
* Images will be output in 1080p/60 even if the connected device
supports 1080p/24.
continued on next page