Sanyo FWBP507FF - HDMI Audio Output

EN 13
4.3. HDMI audio output
“HDMI” > “HDMI” setting
A
Bitstream PCM Re-encode
Media Source
BD Dolby Digital Dolby Digital 2ch PCM Dolby Digital
Dolby Digital Plus Dolby Digital Plus 2ch PCM Dolby Digital Plus
(*1)
Dolby TrueHD Dolby TrueHD 2ch PCM Dolby TrueHD
(*1)
DTS DTS 2ch PCM DTS
DTS-HD
High Resolution
DTS-HD
High Resolution
2ch PCM
(*2)
DTS-HD
High Resolution
(*3)
DTS-HD
Master Audio
DTS-HD
Master Audio
2ch PCM
(*2)
DTS-HD
Master Audio
(*3)
LPCM Multi LPCM Multi LPCM Multi LPCM
(*1)
DVD Dolby Digital Dolby Digital 2ch PCM Dolby Digital
DTS DTS 2ch PCM DTS
MPEG Multi LPCM Multi LPCM Multi LPCM
PCM Multi LPCM Multi LPCM Multi LPCM
Audio CD LPCM 2ch PCM 2ch PCM 2ch PCM
DTS-CD DTS DTS 2ch PCM DTS
AVCHD Dolby Digital Dolby Digital 2ch PCM Dolby Digital
LPCM Multi PCM Multi PCM Multi PCM
Audio file FLAC/WAV 2ch PCM 2ch PCM 2ch PCM
*1) If there is secondary audio or interactive audio, it will be output in Dolby Digital.
*2) Only the core substream is decoded.
*3) If there is secondary audio or interactive audio, it will be output in DTS.
NoteD
• If the connected device is not compatible with HDMI BITSTREAM, audio will be output as multi LPCM or
2-channel down-mixed LPCM depending on the capability of the connected device even if you select “Bitstream”
in “HDMI” setting.
• If “HDMI” is set to “Bitstream” and this unit is connected to a bitstream compatible device, only primary audio of
the BD-Video will be output. (Secondary audio and button sounds will not be output.)
• In order to configure “HDMI” settings, the following conditions must be met:
– “Voice Guide” is set to “Off”.
– This unit is not in resume-on-stop mode. If this unit is in resume-on-stop mode, remove the disc to enable
configuration.