Sanyo FWBP507FF - Voice Guide Settings; Restore Default Settings

EN 43
10.5. Voice guide
HOME A “Setup” A “ ” A “Voice Guide”
Menus to configure various settings for the voice guide function.
1. Use [
] to select “Setup” in the home menu, then press [OK].
2. Use [
] to select “ ”, then press [OK].
3. Use [
] to select the desired setting, then press [OK].
“Voice Guide”:
Turns on/off the voice guide function.
“Voice Guide Volume”:
Configures the volume of the voice.
“Voice Guide Speed”:
Configures the speech rate.
“Voice Guide Pitch”:
Configures the voice pitch.
“Voice Guide Verbosity”:
Configures whether to read detailed information on the current item/operation.
4. Use [ ] to select the desired setting, then press [OK].
5. Press [HOME] to exit.
NoteD
• In order to enable the voice guide function, the OSD language needs to be set to English or Spanish.
Voice guide is not available in French.
• When voice guide is set to on, the HDMI audio setting is fixed to LPCM. Changing the HDMI Audio setting is only
possible when voice guide is set to off.
• While the voice guide function is enabled, operations may slow down.
10.6. Restore default settings
HOME A “Setup” A “ ” A “System” A “Load Default”
This unit will be reset to factory default settings. All the settings will be Initialized.
1. Use [
] to select “Setup” in the home menu, then press [OK].
2. Use [
] to select “ ”, then press [OK].
3. Use [
] to select “System”, then press [OK].
4. Use [
] to select “Load Default”, then press [OK].
5. Confirmation message will appear. Use [
] to select “OK”.
• Initialization will start.
NoteD
• The initial setup screen will appear upon completion of Initialization.