Sanyo HEC-A3700 - Adjusting the Chair

9
ADJUSTING THE CHAIR
6
Adjust the position of the head cover.
2
Press the ON/OFF button.
¡The foot rest will lift up slightly.
Stand
Remote control
1
Press the HOME button to return 
the massager to the home position.
Head cover
4
Place the remote control into the stand.
3
Attach the head cover.
Head cover Back rest
Cord
Hook-and-loop fasteners
Middle of chair
¡ To ensure safety, check the positions of the
massaging rollers before leaning slowly back on the
massager. Do not twist the body, but lean straight
back on the massager, so that the massaging
rollers are in position on either side of the spine.
¡Do not sit down or get up from the chair while the
foot rest or seat are raised.
5
Sit in the middle of the chair.
¡Sit deeply into the massager so that your waist
touches the back rest.
Note:
Note:
CAUTION
¡The head cover contains a weight, so do not shake
it or throw it around, otherwise it may cause injury.
¡Do not attempt to place anything or sit on the foot
rest. The user may fall over, resulting in an accident
or injury.
¡Adjust the position of the head cover so that it does
not touch your shoulders during the massage.
Back rest
Lower the arm
rests.
Foot rest
Remove the hook-and-
loop fastener and pass
it through the cord.
Align the hook-and-
loop fasteners.
Foot rest
You can sit easily by
raising the arm rests
and sitting into the
massager from the
side.