19
AFTER USE
MAINTENANCE PROCEDURES
12
3
¡Do not use substances such as kerosene, thinner, alkaline detergents or bleach to clean.
They will cause discoloration, warping and cracking.
¡Do not wash the head cover.
If this is not observed, discoloration and warping may occur.
Head cover, back rest, seat and arm rests (synthetic leather areas)
Use a soft, dry cloth to regularly clean these areas.
If they are extremely dirty, clean them by the following procedure.
¡Do not wipe using a wet cloth.
Main unit (plastic parts and frame) Remote control
Wipe using a soft dry cloth.
3
Set the POWER switch to the
“OFF” position.
4
Disconnect the power plug.
2
Press the HOME button.
1
Press the ON/OFF button.
¡The massaging rollers will move to their
highest position and then stop.
¡The HOME button will flash
(for approximately 10 seconds).
CAUTION
¡Always be sure to disconnect the power plug from the wall outlet when
not using the massager.
CAUTION
¡
Be sure to disconnect the power cord from the wall outlet before cleaning.
Note:
Note:
Note:
Moisten a soft cloth with diluted
neutral kitchen detergent and
wring it dry, then tap the
surface.
Moisten a cloth in clean water,
wring it dry, and then wipe off
the detergent.
Lastly, wipe the surfaces dry.
¡Do not use an appliance such as a hair dryer to dry the surfaces rapidly.
¡Do not touch PVC products against the massager surfaces for long periods of time. They will cause
discoloration.
Moisten a soft cloth with diluted neutral kitchen
detergent and wring it dry, and then wipe the
surfaces clean, then wipe them dry.
Back rest
Foot rest
To Next Page
Loading...
