7
SETTING UP THE MASSAGER
Moving the massager
Note:
Note:
Setup location
1
CAUTION
2
CAUTION
¡Position the massager on a stable, level surface. Do not use it in
environments which are high in humidity such as bathrooms.
¡Do not release the foot rest suddenly while holding it by hand.
¡Be sure to disconnect the power plug from the wall outlet before moving the massager.
¡Be careful not to run over the power cord or the remote control with the casters.
¡If moving the massager across floor surfaces that can easily get scratched or over
matting or concrete, have two people carry it.
¡Tilt up the front and move the massager on the
casters.
¡Hold the massager by the back rest and foot rest
while moving it.
¡Leave 50 cm (19 3/4") or more of space in front
and 55 cm (21 3/4") or more of space behind the
massager so that it will not hit walls or other
objects when it is being reclined.
¡Do not set up the massager in places which are
subject to high temperatures, such as such places
which receive direct sunlight for long periods of time
and places near heating equipment.
¡Leave a distance of 1 meter (39 1/2") or more
between the massager and audio-visual equipment
such as TVs and radios, otherwise it may be affected
by interference.
¡This will help prevent the floor surface from
becoming scratched and reduce the amount of
noise during operation.
When moving the massager using
the casters
When two people are carrying the
massager
Leave enough space for the
massager to be reclined.
Place carpet or a similar material
over the setup location.
Carpet
Back rest
Foot rest
Caster
Press the ZERO-G button
to fold down the back rest.
Back rest
Foot rest
55 cm (21 3/4")
or more
50 cm (19 3/4")
or more
To Next Page
Loading...
