Sanyo HEC-A3700 - Page 17

16
4
If you would like to have your legs massaged, press the CALF & FOOT button.
Press the SPEED button.
Speed adjustment
Press the WIDTH button.
Width adjustment
¡Each time the button is pressed, the movement
speed (interval) for the massaging rollers changes
and the corresponding indicators illuminate.
¡When the CALF & FOOT button is pressed, massaging will start at the “Medium” setting.
Each time the button is pressed, the strength of massaging changes in the order weak – medium – strong -
off and the corresponding indicators illuminate.
¡Each time the button is pressed, width of the
massaging rollers changes and the corresponding
indicators illuminate.
* The width cannot be adjusted for “KNEADING”,
“RUB-KNEADING”, “KNEAD & TAP” and “SHIATSU”.
If you would like to stop massaging before it is finished by timer
Stopping the chair immediately if you feel an abnormal physical sensation or a problem with the chair itself
¡The ON/OFF button will flash and the massaging rollers will move to the highest position and then stop.
¡If you have changed to some other manual massaging, massaging will continue for approximately 30 minutes
after the ON/OFF button was pressed, and then the timer will expire and massaging will stop.
¡If you are massaging your back and legs at the same time, the respective timers will each operate and each
massaging will finish approximately 15 minutes after they start.
■ After approximately 15 minutes, the timer will expire and massaging will 
stop automatically.
(Weak) (Medium)
Off
(The indicators switch off)
(Strong)
(Slow) (Medium) (Fast) (Narrow) (Middle) (Wide)
Press the ON/OFF button.
Press the STOP button.
Page
14