Sanyo HEC-DR8700 - Operation of Body Pressure Sensor

- 12 -
HEC-DR8700
Operation of Body Pressure Sensor
Detects a pressure applied to the massaging rollers for automatic adjustment to their best position.
Detects a pressure applied to the massaging rollers for measuring spine curving to find out body
contour and shoulder position.
*
Unless the massaging rollers receive a body weight pressure from user for a certain time
during whole body sensor automatic courses or automatic courses, the operation will
discontinue with the massaging rollers retracted.
Normal
When the massaging rollers detach from the body during the Whole Body Sensor
Automatic Course or the Automatic Course, the body pressure sensor will work to
stop the operation by pulling back the massaging rollers for safety.
In such a case, begin the operation again from the start.
10 buttons flash on and off, and the m assage stops
Corrects the positions automatically if the posture varies
when reclining a seat.
(The "ADJUST" lamp of the remote control is flickering while measuring the
shoulder position. Afterward, when the "UP( )/DOWN ( )" lamp is flickering,
the position can be adjusted by pressing the ROLLER POSITION buttons.
The massaging rollers are moved up or down by approx. 1 cm each time the
ROLLER POSITION button is pressed.)
Detects pressure applied to the massaging rollers that depends on spine
curving, and determined its body contour and shoulder positio
n.