-
23
-
HEC-DR8700
Motor/Stress Sensors Operation Confirmation Procedure
Turn ON the POWER switch at the rear of the massager while simultaneously pressing the
ROLLER POSITION "UP" and "DOWN" buttons and "STRETCH" button on the remote controller
(This operation should be started with the POWER switch turned OFF).
When the examination mode is started up, the back rest, foot rest and seat move to their
home position and come to a stop. (The back rest, foot rest and seat do not move when they
are already at the home position.)
Start-up of Examination Mode
Press either " (UP)" or " (DOWN)" button of the LOWER BODY adjustment on the
remote controller. (move for 3min)
Seven motors work at the same time when they push "REPEAT" button.
Massage motor and Tapping motor is fastest moves.
Elevation motor and Strength motor goes to an upper
point and lower point and return.
Reclining motor (foot rest/back rest/seat) repeat the expansion and
contraction.
Movement / a stop is possible with a "REPEAT" button again and again.
*After you exchanged the massage unit, reclining motors or PCB, confirm
the movement by this function.
When there is abnormality, the operation of the examination mode stop and display
abnormal indication, find out the problem and repair.
As for this function , the sole warmer, the air pump / the valve also move at the same time.
"Grip the Sensor" on the remote control will be turned off and "AUTO " will be
illuminated when touch the sensor on one side with your fingers (hand).
Afterward, touch the sensor on other side in the same way
and confirm that "AUTO " will be illuminated.
* If there are any problems, find out the problems and repair.
Stress Sensor Operation Confirmation
"Press" on the remote control will be turned on when press the massaging rollers.
Body Pressure Sensor Operation Confirmation
To remove the examination mode, turn OFF the POWER switch.
Air-Bag Operation Confirmation
Motor Operation Confirmation
display
5. Reclining motor
(Seat)
<Seat under><Back rest>
7. Reclining motor
(Foot rest)
6. Reclining motor
(Back rest)
1
4
4
3
3
22
4,
Elevation motor
2,
Massage motor
3,
Strength motor
1,
Tapping motor
"REPEAT"
button
Sensors
(Touch separately)
To Next Page
Loading...
