Sanyo HEC-DR8700 - Massaging: Manual (Roller) Courses; Manual Roller Massage Operations

- 24 -
HEC-DR8700
Replacement Procedure
(1) How to remove Arm Rest, Cover
(Arm Rest Lower) and Cover (Under)
1, Remove one holder (cord holder) set screw
and take off the holder (cord holder).
Photo-1
2, Gently pull the lower portion of the cover
(remote control stand) toward you and take
off the cover (remote control stand).
Photo-1
3, Remove three stand (remote control) set
screws and take off the stand assembly
(remote control). Photo-2
4, Take off the ornament (cover side) on the
cover (screw cap). Photo-1
5, Insert the flathead screwdriver into lower
portion of the cover (screw cap), pull toward
you and take off the two cover (screw cap).
Photo-1
6, Remove two arm rest (right) set screws, lift
up and take off the arm rest (right).
Photo-2
7, Remove four cover (arm rest lower right) set
screws and take off the cover (arm rest lower
right). Photo-2
8, Take off the ornament (cover side), arm rest
assembly (left) and the cover (arm rest lower
left) in the same way. Photo-1,2
9, Rotate main body of the chair so the back of
the head rest is on the floor and the foot
rest is in the air. Photo-3
10, Lift up the foot rest and insert a screwdriver
and so forth into the link to fix the link.
Photo-3
11, Remove eight cover (under) set screws and
take off the cover (under upper right), the
cover (under upper left) and the cover
(under front). Photo-3
12, Lower the foot rest. Photo-3
Holder (cord holder)
Cover (screw cap)
Photo-1
Stand assembly (remote control)
Cover (remote
control stand)
Cover set screws
Cover (arm rest lower) right
Arm rest
Stand assembly
(remote control)
Stand set screws
Arm rest set screws
Photo-3
Photo-2
Insert flathead screwdriver
Cover set screws
Screwdriver, etc
Cover (under upper) right
Cover (under front)
Cover (under upper) left
Ornament (cover side)