-
30
-
HEC-DR8700
Replacement Procedure
7,
Turn the pulley (elevation) clockwise, move the
massage unit upwards, and take off a drive
wheel A from a back frame guide toward you.
Photo-20,21
* When taking off the drive wheel A, hold the
massage unit firmly.
8, With the drive wheel A removed, further turn
the pulley (elevation) clockwise.
Photo-21
9, When right and left gears are disengaged
from the back frame gears (rack), take off
the massage unit from the massager body.
Photo-21
(11)
How to Reassemble the Massage Unit
1, Tape a lever of a micro switch.
For the purpose of preventing the lever of
the
micro switch
from being deformed or
damaged by incidentally hitting it when
installing the massage unit.
* After installing the massage unit, peel the
tape. Photo-22
2, Fit the massage unit in parallel so that the
first right and left gear (rack) teeth engage
with the right and left gears of the massage
unit simultaneously. Photo-23
Drive wheel A
Pulley (elevation)
Tape the lever to
protect it.
Pulley (elevation)
Photo-20
Photo-21
Photo-22
Gears
Photo-23
Micro switch
Move upwards
To Next Page
Loading...
