Sanyo HEC-DR8700 - Page 35

HEC-DR8700
Replacement Procedure
- 35 -
Mar./2010 Printed in Japan
SANYO Electric Co.,Ltd
Osaka, Japan
(23) Replacement of Foot rest comp.
1, Rotate main body of the chair so the back of
the head rest is on the floor and the foot
rest is in the air. Photo-40
2, Lift up the foot rest and insert a screwdriver
and so forth into the link to fix the link.
Photo-40
3, Remove eight cover (under) set screws and
take off the cover (under upper right), the
cover (under upper left) and the cover
(under front). Photo-40
4, Disconnect each air hose and disconnect
connector (heater B). Photo-41
5, Loosen nuts of the wire (foot rest slide) and
remove the wire (foot rest slide). Photo-41
6, Cut the bands and unzip the fastener between
the foot rest section and seat section.
Photo-42
7, After lower the foot rest, lay down the main
body with its left side facing downward.
8, Remove E rings and pull out fixing pins and
take off the foot rest.
Photo-42
Photo-41
Connector (heater B)
Wire (foot rest slide)
Nuts (wire)
Air hoses
Air hoses
Air hose
joint
Connector (heater B) joint
Photo-42
Bands
Fastener
Bands
E ring and fixing pin
E ring and fixing pin
Foot rest
Cover set screws
Screwdriver, etc
Cover (under upper) right
Cover (under front)
Cover (under upper) left
Photo-40
Fixing pin
Fixing pin
E ring
E ring
Foot rest