17
1
3
4
5
2
HIGH
(Lit) (Lit)
(Neither lamp is lit)
OFF
MASSAGING
(WHOLE BODY SENSOR AUTOMATIC COURSES)
Open the cover of the remote control.
Turn the sole warmer ON/OFF.
Adjust the angle and position of the back rest and the foot rest.
(See page 12
-
15)
●
●
●
●
●
Press the SOLE WARMER button. The sole warmer mode changes as follows each
time the button is pressed. The current mode can be identified by the status of the
corresponding lamp (when the sole warmer is on, the SOLE WARMER HIGH or
LOW lamp is lit).
If you feel that the sole warmer is too hot, turn it off by pressing the SOLE
WARMER button.
*
*
When the room temperature is low, such as in winter, it takes some time to warm up or you may not feel warm.
When the sole warmer is in LOW mode, the heating temperature is
adjusted automatically based on the room temperature.
Room temperature is high
･･･
Heating temperature is set to LOW.
Room temperature is low
････
Heating temperature is set to HIGH.
LOW mode saves power consumption by approximately 15 % (compared
to HIGH mode, at room temperature of 25°C (77°F))
Press the OPERATION ON/OFF button.
Press
When the foot rest is fully lowered, the foot rest will rise a little.
When the massaging rollers are not located in the upper section, the massaging
rollers will move to the upper section and stop. [at the origin]
(During the movement, the icon of “ORIGIN” on the remote control flickers.)
4
1
3
2
4
When the button is pressed, the lamps of the sole warmer and remote control
will illuminate, and the sole warmer will turn on.
LOW
(See page 23)
6
To Next Page
Loading...
