16
FEATURES OF COURSES
WHOLE BODY SENSOR AUTOMATIC COURSES
Massaging on the degree of stress and stiffness detected by sensors
Sub
-
courses
Features of program
FULL AUTO
Fully automatic massage based on the
degrees of stress and stiffness
STIFFNESS
Shiatsu massage to counteract stiffness
＊In stress measurement mode, only air massage
of your legs is performed.
RECOVERY
Tapping massage to ease muscle fatigue
RELAX
Kneading massage to relax the whole body
QUICK
Short massage to promote blood circulation
(Reduced time course)
＊Massaging of each course is possible without placing fingers (hand) on the sensor.
In this case the degree of stress and stiffness is not detected.
＊The degree of stress and stiffness are measured by placing your fingers (hand) on the sensors.
Sub
-
courses
Features of program
AUTOMATIC COURSES
Easy 1 or 2
-
button operation
Massages automatically by effective
combination of gripping,kneading up,
kneading down,tapping, combo (tapping
and kneading), shiatsu, full stretching,
partial stretching, focus stretching,and
lower body (air) massage.
NECK & SHOULDER
LOWER BACK
STRETCH
COMFORT AIR COURSE
Massages mainly the neck and shoulders
Massages mainly the waist and lower back
Air massage of the whole body
MANUAL COURSES
Full programable upper and lower body massage
Massages with your own adjustment of
massage types such as gripping,
kneading up, kneading down, tapping,
combo (tapping and kneading), shiatsu,
full stretching, partial stretching, focus
stretching, and lower body (air) massage.
Multiple roller massages (for upper body) and air
massages(for lower body) are available.
(See page 17
-
20)
(See page 21
-
22)
(See page 23
-
27)
●
●
●
●
If you have felt abnormal physical sensation
or want to stop the massager immediately.
Press the OPERATION ON/OFF button. Press the INSTANT STOP button.
Press the button for the current operation.
To stop the massage during operation.
All the massaging will stop.
(The massaging rollers are moved
to the upper position and remain
in that position.)
The massaging that corresponds to the
pressed button will stop. (The Massaging
rollers will stop at that point.)
All the massaging will stop and the lamp of
the remote control will turn off.
When you want to restart massaging, press
the OPERATION ON/OFF button.
(The massaging rollers move to the upper
position and remain in that position.)
After the movement, repeat the operation to
begin a massage.
Features of courses
Massages using a whole
body Sensor automatic
course program based on
the degree of stiffness
detected by sensors.
Stretch to relax the whole body
Features of program
When the massaging rollers detach from the body during the Whole Body Sensor Automatic Course or the
Automatic Course, the body pressure sensor will work to stop the operation by pulling back the massaging
rollers for safety. In such a case, begin the operation again from the start.
Automatic massages based on the
degrees of stress and stiffness
measured by sensors prior to
massaging.
To Next Page
Loading...
