20
●
●
●
Try to be relaxed while you are massaging.
＊The measurement results show the biological response of your body and may not match your feelings of stress and stiffness.
＊｢Heart rate variability｣ depends on age that is classified into three generations.
NOTE
Finishes massaging automatically by timer
operation.
■
The massaging time differs according to the detected stiffness,
but the maximum is approx. 20 minutes.
Massaging rollers are moved to the upper position, and stop
massaging automatically.
The beep sounds and the lamp on the remote control will turn off.
Stiffness
Measured based on the amount of perspiration on your hand.
Stress
Measured based on ｢heart rate variability｣.
Immediately after taking a bath or when watching TV, you may not be
able to measure the degrees of stress and stiffness correctly.
◆
◆
◆
◆
◆
◆
◆
◆
◆
7
●
●
④ Massages according to detected stiffness.
Adjusts the operation and strength of standard massaging
according to the measured degree of stiffness.
＊FULL AUTO : Massages according to detected
stress and stiffness.
Adjust the strength of massage.
UPPER BODY
LOWER BODY
●
●
Each time the UPPER button is pressed, the strength of upper body
massaging can be adjusted in five stages.
(The strength is displayed by the lamp on the remote control.)
Each time the LOWER BODY STRENGTH
ADJUST button is pressed, the strength
of lower body massaging (air) can be
adjusted in three stages. (The strength
is displayed by the lamp on the remote
control.)
＊If you continue to press the “ ”
button until the illumination of
the lower body strength scale
turns off, you can turn off the
massaging of the lower body.
If you press the “ ” button,
the massaging will resume.
8
SHIATSU(CALF/SOLE)
When it is felt that the massaging on the soles
or calves is too strong even when reducing the
strength of lower body (air) massaging, use the
SHIATSU ON/OFF button or put a towel etc. on
those massaged parts.
The ON/OFF state of sole/calf shiatsu
massage toggles each time the button
is pressed.
(when calf/sole shiatsu massage is on,
the corresponding lamp is lit.)
The massaging
rollers are moved
to the upper
position and are
stopped.
[at the origin]
The STRESS indicator disappears.
●
To Next Page
Loading...
