Sanyo HEC-DR8700 - Massaging: Automatic Courses; Selecting and Operating Automatic Courses

21
MASSAGING (AUTOMATIC COURSES)
1
4
5
2
Turn the sole warmer ON/OFF.
●
●
●
●
Press the OPERATION ON/OFF button.
Press
(See page 17)
Press the desired Automatic Course button.
NECK & SHOULDER
STRETCHLOWER BACK COMFORT AIR COURSE
Massages mainly the
neck and shoulders
Massages mainly the
waist and lower back
COMFORT AIR COURSE can be operated simultaneously with NECK & SHOULDER or LOWER BACK.
STRETCH COURSE cannot be operated simultaneously with any other courses.
Refer to the page 32 regarding the massaging contents of Automatic Courses.
Change of course while massaging, or change to the Whole Body Sensor Automatic Courses
or the Manual Courses, is possible.
Adjust the positions of the back rest and the foot rest.
(See page 12
-
15)
4
1
5
2
3
4
Stretch course
The back rest and foot rest angles are adjusted automatically.
●
WARNING
Air massage of the
whole body
Stretch to relax the
whole body
3
Be sure to check that there is no person (children in particular), or any pets under
the foot rest and that there are no other obstructions in the way before reclining
the back rest or lowering the foot rest or when using the stretch function.
In addition, do not leave the foot rest in the raised position when not in use.
If this is not observed, accidents or injury may occur.
●
●
●
When the foot rest is fully lowered, the foot rest will rise a little.
When the massaging rollers are not located in the upper section, the massaging
rollers will move to the upper section and stop. [at the origin]
(During the movement, the icon of “ORIGIN” on the remote control flickers.)
When the button is pressed, the lamps of the sole warmer and remote control
will illuminate, and the sole warmer will turn on.
Open the cover of the remote control.
(See page 23)