22
The massager starts massaging automatically.
①
●
●
Measure the position of shoulder.
Check if the position of shoulder is correct. If not, adjust the position using the ROLLER POSITION
buttons. (The ROLLER POSITION buttons can also be used while massaging is in progress.)
②
The following explanation assumes that you are performing a NECK & SHOULDER course.
The position of current
massage flickers.
The timer will operate and then stop.
After the rollers have retracted,
the display will turn off.
Massaging concentrated
on the neck and shoulders
will be carried out.
Adjust the strength of massage.
UPPER BODY
●
Each time the UPPER button is pressed,
the strength of upper body
massaging can be adjusted
in five stages.
(The strength is displayed by
the lamp on the remote control.)
LOWER BODY
●
Each time the LOWER BODY STRENGTH
ADJUST button is pressed,
the strength of lower body
massaging (air) can be adjusted
in three stages. (The strength
is displayed by the lamp on
the remote control.)
The massaging rollers are moved to the upper position and are stopped automatically approx. 15 minutes
after starting the operation. The beep sounds and the lamp on the remote control will turn off.
Finishes massaging automatically by timer operation.
■
6
7
Measurement of shoulder position
(Sit deeply on the massage chair and raise your head slightly. The matching of the
position of shoulders may not be possible if the head is leaning on the back rest.)
Decides the position of shoulder.
Massaging rollers move up and down to measure the position of shoulder.
Massaging operation at recognized position of shoulder.
Check that massaging rollers match the position of your shoulder.
If not, when the lamp of is flickering (a beep sounds), adjust the
position by pressing the ROLLER POSITION buttons.
When it is difficult to adjust with ROLLER POSITION button, move
your body for adjustment. The height that can be adjusted is
between approx. 150 (59
1
/
4
") to 180 cm (71") .
Starts the massaging of selected course.
Displays the aim of massaging positions, the stiffness, body pressure and the remaining
massaging time on the remote control.
The massaging rollers are moved up or down by approx. 1 cm (
3
/
8
")
each time the ROLLER POSITION button is pressed.
When it is felt that the massaging on the soles or calves is too strong even when reducing the strength of lower body
(air) massaging, use the SHIATSU ON/OFF button or put a towel etc. on those massaged parts. (See page 20)
Massaging rollers
Position too high
Position too low
Appropriate position
(Remote control display)
To Next Page
Loading...
