Sanyo HEC-DR8700 - Stress and Stiffness Measurement Process

18
●
The button that is blinking indicates the currently selected Whole Body Sensor Automatic Course.
Press the button to select the desired course.
①
Press the AGE button corresponding
to your age.
②
Grip the sensor controller with your fingers (with
both hands) so that four sensors are touched.
●
●
If you are unable to use both hands, grip the sensor controller with one hand and
move it so that the remaining sensors touch the skin of the other hand.
●
●
※Keep calm during stress measurement.
If your skin is dry, the degree of stress/stiffness may not be measured
correctly. In such a case, press the SENSOR ADJUST button (the
SENSOR ADJUST lamp is lit when the sensor adjustment mode is ON).
Wash your hands clean for the correct degree of stress.
(Sebum or dirt interrupt the stress measurement.)
●
●
●
●
Press the desired Whole Body Sensor Automatic Course button.
Kneading massage to
relax the whole body
QUICK
Short massage to promote
blood circulation
(Reduced time course)
Change of course during massaging, or change to the Automatic Course or the Manual Courses, is possible.
Refer to the page 31 and 32 regarding the contents of Whole Body Sensor Automatic Courses.
NOTE
5
6
RELAXRECOVERY
Tapping massage to
ease muscle fatigue
STIFFNESS
FULL AUTO
Fully automatic massage
based on the degrees
of stress and stiffness
Shiatsu massage to
counteract stiffness
Stress is measured.
Before gripping the sensor After gripping the sensor
Sensors
Rear of sensor controller
When stress measurement is completed...
The measured degree
of stress is displayed
on the remote control
display.
『 』
6
To the stress measurement
『 』
7
To the stiffness measurement (See page 19)
How to grip the sensor controller
when the icon is shown
on the remote control display
How to grip the sensor controller
when the icon is shown
on the remote control display
■
in turn. And stiffness measurement will start.
Be sure to place your fingers (hand) on the sensor. The
degree of stress cannot be measured if your fingers (hand)
are not placed on the sensor. (If your fingers (hand) are not
gripping the sensor, “Grip the sensor” on the remote
control will be illuminated. (The icon lights up when
the user is being measured.)) If your fingers (hand) are not
touching the sensor points, massages will be carried out
according to the standard operation of the selected course.
『 』and『 』 icons flash (a beep sounds)
●
●
・You do not grip the sensor controller in a calm state.
・Your heart rate is extremely high, after exercise for example.
・Electrocardiographic monitoring with both hands is not possible.
■
When stress measurement starts...
Air massage of your legs starts.
Stress measurement is not possible in the following cases:
●
In some cases it may take maximum 2 minutes 30 seconds
for the sensor to activate.