Sanyo JA 250 - SPECIFICATIONS

NOTE:
The below mentioned specifications are mainly based on the IHF measurements standard.
directly be compared with specifications based on the DIN standard or ther standards.
Continous output power .......
re e 8 # @ @#
Total harmonic distortion
Input sensitivity and impedance
PHONO” s63725 oars ee ea Sees
AUX/TUNER/TAPE PLAY .
Phono overload level ..........
Output level
PACE OREC oo eso ee tees
Frequency response
ss 8 8 #* © @ 8&8 @ 6
SPECIFICATIONS
25W x 2 (at 8.ohms,
0.3% distortion)
0.1% (20 W output,
8 ohms)
2.5 mV/47 kohms
. 180 mV/47 kohms
130 mV RMS (at 1kHz)
150mV
20 — 20000 Hz
Graphic equalizer controls ...
High filter response ........
Loudness control response
100 Hz/10 kHz
Power consumption
Weight (Approx.) .........
Specifications subject to change without notice.
Signal to noise ratio .......
Power requirements .......
AC output socket .........
Dimensions (Approx.) ......
They can therefore not
Shama +10 dB (63/250/1000/
4000/16000 Hz)
eee 7 kHz (—6 dB/oct.)
Satoh We +8 dB/+4 dB
ie hee 90 dB
ay hea ees AC: 220V, 50Hz
ere 130 W
5 Sb, ase AC: 18 V, 300 mA
satan 420 (W) x 220 (D) x
85 (H) mm
(16-1/2” x 8-5/8” x3-3/8"’)
BS ach es 4 kg (9 Ibs.)
WM-8507
AS