33
PC ADJUST
This function is used to adjust the position of image displayed on screen.
It can be selected when the LCD TV could be received PC signal
and in PC mode. (Refer to "SIGNAL MODE COLUMN" on page 39.)
Press POINT ◄► buttons or ENTER button to enter PC ADJUST menu.
It can be select "AUTO ADJUST", "H-POSITION", "V-POSITION",
"PHASE", "CLOCK" or "AUTO SHUT DOWN" to adjust.
Press POINT ◄► buttons, and the TV automatically detects
incoming signal, and adjust itself to optimize its performance.
If the image is not displayed properly, a manual adjustment is
required (Refer to following adjustments).
Eliminate disorder from the image. Press POINT ◄► buttons to
adjust PHASE. (0~100)
AUTO ADJUST
PHASE
Press POINT ◄► buttons to set AUTO SHUT DOWN ON or OFF.
When PC is switched Off, ''NO SIGNAL'' appears for 30 seconds,
TV will be automatically switched to Backlight off mode.
During Backlight Off Mode within 10 minutes, TV will be switched
to On Mode if PC is switched On.
After Backlight Mode continues for 10 minutes, it will be switched
to Standby Mode. During Standby mode, TV will not be switched
to On mode even if PC is switched On.
During Backlight Off mode, POWER indicator will become green.
POWER ON/OFF button, NUMERIC (0-9) buttons and CHANNEL
up/down buttons are enabled to switch On TV.
AUTO SHUT DOWN
MENU OPERATION (PC mode)
SETUP
■ Press BACK button to return to the previous menu.
■ Press MENU button or wait for 5~60 seconds (refer to
"DURATION" on page 28) to exit menu operation.
SETUP MENU
1
2
Press MENU button and the main menu will appear.
Press POINT ◄► buttons to select "SETUP", and will display
SETUP menu.
Press POINT ▲▼ buttons or ENTER button to enter into
SETUP menu.
Press POINT ▲▼ buttons to select the item desired.
3
Press POINT ◄► buttons to enter the item selected.
4
SETUP
CHILD LOCK
ON
ECO
OFF
DYNAMIC AI
ON
ACTIVE CONTRAST
ON
PC ADJUST
SHOP MODE
SELECT
ADJUST
BACK EXIT
::
:
:
SETUP
CHILD LOCK
ON
ECO
OFF
DYNAMIC AI
ON
ACTIVE CONTRAST
ON
PC ADJUST
SHOP MODE
SELECT
ADJUST
BACK EXIT
::
:
:
Note:
● "PC ADJUST" is only active in PC mode.
● For the details, please refer to "SETUP" on pages 29-30.
SETUP
AUTO ADJUST
AUTO SHUT DOWN
ON
PC ADJUST
V - POSITION
CLOCK
PHASE
H - POSITION
SELECT
ADJUST
BACK EXIT
::
:
:
The horizontal picture position will be moved to the left side by
pressing POINT ◄ button. And it will be moved to the right side by
pressing POINT ► button. (0~100)
The vertical picture position will be moved down side by pressing
POINT ◄ button. And it will be moved up side by pressing POINT
► button. (0~100)
H-POSITION
V-POSITION
Eliminate flicker from the image. Press POINT ◄► buttons to
adjust CLOCK. (0~100)
CLOCK
LCD-19K40(R-S-W)ENG.indd 33LCD-19K40(R-S-W)ENG.indd 33 4/13/2010 1:36:24 PM4/13/2010 1:36:24 PM
To Next Page
Loading...
Need help?
General
