Sanyo PDG-DWL2500 - Connecting to Video Equipment

-17-
Mechanical Disassembly
A
b Ballast Board and Thermal Switch(SW902) removal
1. Remove 2 screws A(M3x6) to remove Side lamp shield.
2. Remove 4 screws B(M3x8) to remove the Lamp house frame.
3. Remove 2 screws C(T3x8) to remove the Ballast board, remove 1 screw
D(T3x8) to remove the Trigger box , remove 2 screws E(M3x6) to remove
the Ballast socket.
Fig.5
A
B
B
B
E
E
C
C
B
D
(M3x10)x1
SW902
Thermal switch
Thermal switch
holder
Lamp house
frame
Trigger box
Ballast board
Socket
Note on mounting the thermal switch (SW902)
Thermal switch
holder
SW902
Thermal switch
Put the thermal switch on the
holder and slide it in the arrow
direction and then tighten the
screw to fix the thermal switch.
Side lamp
shield