Sanyo PDG-DWL2500 - Top Controls and Indicators

12
Part Names and Functions
q POWER indicator
– Turn red when the projector is in the stand-by
mode.
– Turn green while the projector is under operation
(pp.20, 74).
– Blink green in the Power management mode
(pp.57, 74)
w WARNING TEMP. indicator
Emit a red light when the projector detects abnor-
mal condition. This also blinks red when the inter-
nal temperature of the projector exceeds the oper-
ating range (pp. 64, 74).
e LAMP REPLACE indicator
Turn yellow when the life of the projection lamp
draws to an end (pp. 67, 74).
r 3D indicator
Turn blue when the projector is in 3D mode (pp.
48-49, 74).
t SELECT button
– Execute the selected item (p.23).
– Zoom in and out the image in the Digital zoom
mode (p.39).
y ON/STAND-BY button
Turn the projector on or off (pp.20-22).
u AUTO SETUP button
Execute the setting of Auto setup (includes Input
search function and Auto PC adj. function). (pp.26,
51)
i KEYSTONE button
Correct the keystone distortion (pp.26, 40, 47).
o MENU button
Open or close the On-Screen Menu (p.23).
!0 Point ed7 8 buttons
– Select an item or adjust the value in the On-
Screen Menu (p.23).
– Pan the image in Digital zoom + mode (p.39).
– Adjust the volume level (with Point 7 8 buttons)
(p.27).
– Adjust the screen size (with Point ed buttons)
(p.25).
!1 Infrared Remote Receiver
The protruding shape allows wide-angle remote
control signal reception.
Top Controls and Indicators
q w e r
y u i o !0
t
!1