Sanyo PDG-DWL2500 - Input Source Selection (Computer 2: RGB)

31
Choose Computer 2 (RGB) by press the COMPUTER 2
button on the remote control.
4Note:
When the Input Search function is set to
On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.51).
COMPUTER 2 button
Remote Control
1
2
Press the MENU button to display the On-Screen
Menu. Press the Point ed buttons, move the highlight
to Input and then press the Point
8
or the SELECT
button.
Use the Point ed buttons to select Computer 2 and
then press the SELECT button.
Input Menu
Computer 2 (RGB)*
3
When Computer 2 is selected, analog RGB input
source will be selected directly.
Input Source Selection (Computer 2: RGB)
Direct Operation
Menu Operation
Computer Input
4Note:
*
COMPUTER 2 can not be selected when
using the COMPUTER IN 2/ MONITOR
OUT terminal as MONITOR OUT.
"Monitor out" message will appear on the
screen when COMPUTER 2 button is
pressed while using the COMPUTER IN
2/ MONITOR OUT terminal as MONITOR
OUT.