Sanyo PDG-DXL100 - Page 31

PDG-DXL100
Condential
3-5
No Symptom Procedure
12
Remote Control/
Control Panel Failed
- Remote Control
a. Check Battery
b. Check Remote Controller
c. Check Keypad Board
d. Check Main Board
- Control Panel
a. Check FPC
b. Check Keypad Board
c. Check Main Board
13 Function Abnormal
- Do “Factory default” of the OSD Menu
- Check Main Board
- Check DMD Board
14 Audio Abnormal
- Ensure that the signal cables and source are work as well
- Ensure that your Projector is not in “Mute” mode
- Check the interior Speaker of the projector
- Check the exterior Speaker that you are using
- Check Main Board
15
Network Function
Abnormal
- Ensure RJ45 Connector work well (Normal Status: Before
joining RJ45 line,Orange LED ashes; after joining
RJ45 line,and Internet transmission speeds over 100MB/
second,Green LED will light.)
- Check Internet Source and LAN Module Board if LED
message is in abnormal status
- Check Main Board if LED message is in normal status
16 Forget Password
- If the user forget the projector’s password, executing below
steps can solve the problem:
(1) Power on the projector.
(2) Get into service mode (please refer to 4-2 for details)
(3) Select “factory reset”. click “enter” button.
(4) The “security settings” in OSD menu will change to “OFF”in OSD menu will change to “OFF” will change to “OFF”
and user can use the default password (1234) to set new
password .