Sanyo PID-42NE1 - Page 22

22
Disassembly and Assembly instructions
When replacing the cabinet back, secure the lead wires for the
speaker and key SW board to the cabinet back with repair tape.
The circle mark in the picture below shows where to affix the tape.
(Adehesive cloth tape)
42 t
yp
e
47 t
yp
e
䕔 Caution
Affix the tape so the lead wire is sealed tightly onto the
cabinet back. If the lead wire pops up, it may get close
to the board or a high temperature area and cause a
chattering noise.
When replacing the button unit that is installed onto the key
SW board, affix a spacer sheet onto the button unit.
Button Unit
SPACER SHEET C-N2JP
When replacing the cabinet back, secure the lead wires for the
speaker and main board to the cabinet back with repair tape.
42 type
Adehesive cloth ta
pe
E
p
ox
y
ta
p
e
Lead wire䠖Main KSPL-S
p
eaker L
Lead wire䠖Power K6A-Main
Lead wire䠖
Jack K10E-Main K72E,
Jack K10D-Main K72D
47 type
Lead wire䠖
Power K6A-Main K16A,
Jack K10E-Main K72E,
Jack K10D-Main K72D
E
p
ox
y
ta
p
e
Adehesive cloth ta
pe
Lead wire䠖Main KSPL-S
p
eaker L