Sanyo PLC-XF45 - APPENDIX; Troubleshooting Common Issues

-48-
12. Flicker reduction
Input mode Computer.
Input signal 1 dot line computer signal
Set the image to "Service mode."
Adjust each color for minimum flickers with the Volume + - buttons.
Group No. Screen
200- 17 Display only green light.
200- 18 Display only red light.
200- 19 Display only blue light.
13. White balance adjustments
Input signal 16 step gray scale signal
Set the image to "Service mode."
Adjust each item value with the Volume + and - buttons and to obtain better white
balance.
Group No. Lamp mode Input mode Adjustment value.
930- 0 See note.
210- 14 and 16 4 lamp mode AV Better white balance.
200- 14 and 16 4 lamp mode Computer Better white balance.
930- 1 See note.
211- 14 and 16 Lamp 1-4 of 2 lamp mode AV Better white balance.
930- 2 See note.
212- 14 and 16 Lamp 2-3 of 2 lamp mode AV Better white balance.
Note :
■ . If the data value appears "11" on the screen, go to next item.
■ . If the data value appears "0" on the screen, set the data value to "10"
and go to next item.
■ . If the data value appears "99" on the screen, wait until it is changed to
"0". Then set the data value to "10" and go to next item.
14. Unevenness color correction
If you find the Unevenness color on the screen, please
correct it by using the proper computer and "color shading
correction" soft ware supplied separately.
The soft ware can be ordered as follows:
"color shading correction"
Service part NO. : 645 051 2308