EasyManua.ls Logo

Sanyo VPC-E1 - MOTION COMPENSATION (IMAGE STABILIZER)

Sanyo VPC-E1
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English 60
AFTER USING THE CAMERA IN WATER
After using the camera in water, wash it with fresh water and dry it completely
.
1 Turn off the camera, and close the battery/card compartment cover
securely.
2 Wash the camera with fresh water.
h
Fill a shallow basin with fresh water, and immerse the closed camera for
about 5 minutes. Rotate the monitor unit several times to clean it
completely.
3 Allow the water to drain out through the drainage holes.
h
Drain the water through the five drainage holes.
4 Dry the camera.
h
Use a dry cloth to wipe off any drops adhering to the camera, and leave
it to dry completely in a well-ventilated place away from direct sunlight.
h
Water may seep out from the drainage holes if the camera is not
completely dry inside. Take special care not to let water get inside the
battery/card compartment.
h
Do not use a hair dryer or the like to dry the camera. Exposing the
camera to high temperatures may cause the camera and/or waterproof
seal to become deformed.
Drainage hole
Drainage hole
Drainage hole
Monitor unit Monitor unit

Table of Contents

Related product manuals