Sargon Prospector - Page 39

Adjust
the table untilthe
display indicates
0,0.
Then
perform
cutting operation
and
press
NEXT.
The DRO will
then
display the coordinates
of
holes
2,
3, and
so on.
Press
NEXT each time
you
are ready
to advance to
the
next
step.
When
the
holes
are
finished, the
Prospector
will
display END
OF CIRCLE
(see
Figure
40):
Note: Entering
Run Mode
automatically
results
in INCR Mode.
Figure 40:
END
OF CIRCLE
To
continue
around the same
center,
press
NEXT
after the
momentary
RETURN
TO
ZERO message is
displayed and
move
the table to 0,0.
To
exit Run Mode
at any time,
press
MODE.
w
IW,
37