Sargon Prospector - Page 42

ln
ABS
Mode, move
the
table so that
the spindle
is
pointing
to the first hole.
Then
change to
INCR Mode and
zero
the axes by
pressing
the
SET buttons.
Adjust
the table
until
the display
indicates
0,0.
The
first
hole is
the starting
position
of
the
line,
so
perform
cutting
operation.
Then
press
NEXT
and
move
on
to other holes.
The DRO
will
display the
coordinates of
holes
2, 3, and
so
on.
Press
NEXT
each
time
you
are ready
to advance to the
next
step.
When
the
holes
are
finished,
the
Prospector will
display END OF LINE
(see
Figures 44
and
45):
Note:
Entering
Figure 44: HOLE
Run Mode
automatically
results
in INCR Mode.
H
W
40