Sargon Prospector - Page 47

Note:
1. The MEC
procedure
is
performed
one
axis at a
time.
2. For best
results, the display should
be
calibrated
in
units
in which it will
be used
(inch
or
mm).
3.
ABS and
INC
modes
always
have
the
same calibration
factor for a
given
time.
4.
Standard
machine
hop
procedures
are used
for
gauge
block
set
up
and
measurement.
--\.
\'\
t\
t\
h\
'")
/
'-'n
t\
I
l,j
I
45