OPERATION - SETTINGS
- Open the hinged lid and fill water into the water tank. For this operation, remove the
Ice cube storage container. Fill the appliance with water only up to the mark. Place the storage container
again
- Close the hinged lid.
- Switch on the unit by pressing the start button on the control panel.
- The ice cube maker produces 3 different ice cube sizes that can be selected manually. Press for
the selection the corresponding button on the control panel (see Structure and Parts). To make the larger
ice cubes, the appliance needs more time. If the ambient temperature is below 15°C, small ice cubes are
recommended to prevent the ice cubes from sticking together.
- Empty the ice cube storage bin after each run, it is not designed for prolonged storage of ice cubes
suitable.
Ice cube making:
- The water is pumped from the water tank into the water tray.
- The evaporator located in the water tray ensures that the water turns to ice.
- Ice cube production takes approx. 7 - 15 minutes, depending on the set size of the ice cubes.
- As soon as the production cycle is finished, the water tray swings back and the remaining water flows back into the
water tank. The ice cubes fall from the evaporator. The water tray then rotates forward again and the ice pusher
pushes the ice cubes into the storage basket.
- After the water tray has turned back to the horizontal position, the next production cycle is started automatically.
- If there is a lack of water, the control light "Low water level" lights up and the appliance is automatically switched off.
Switch the appliance on again and fill it with water again (up to the mark), the control light goes out.
- As soon as the ice cubes have reached the sensor in the storage container, the 'Full ice cube tray' indicator light lights
up. The appliance stops and restarts automatically as soon as you have emptied the ice cube tray.
- If the indicator lights "Full ice tray" and "Low water level" light up at the same time although there is still water in the
water tank and the ice cubes have not reached the sensor, please check whether some ice cubes may be blocked in
the water tray. If this is the case, remove the ice cubes. If there are no ice cubes blocked, turn the water tray slightly by
hand. The appliance will restart after 3 - 5 minutes.
ICE DICE
approx. 23 x 29 mm approx. 25 x 31 mm approx. 27 x 33 mm
CLEANING
Wipe down or wipe out the outside and inside with a damp, soft cloth. You can use a light cleaning agent. Do not use abrasive,
bleaching, corrosive or scratching cleaning agents/cleaning aids, as this could damage/scratch the surfaces.
Clean the storage container, the water tray and the ice pusher daily.
Clean the ventilation slots from time to time, as dust and dirt can block the slots. To do this, remove the plastic cover on both
sides by loosening the screws. Clean everything with a soft brush or hand brush. In addition, use a hoover.
To Next Page
Loading...
