4
Consignment consists of:
electronic analytical balance
(1)
, protective ring
(13)
, line cable
(12)
, operating mode switch
(3)
,
pan
(10)
, shield plate
(14)
, dust cover
(15)
.
Resetting the line voltage
Pull out and turn the voltage selector
(16),
and
plug it in such that the desired voltage is aligned
with the arrow mark. Be sure to write the new
setting on the manufacturer’s label
(17)
.
Line voltage selector (20)
Compare factory-set voltage to avaible local line
voltage and reset, if necessary.
Installing the pan
Proper sequence:
-
shield plate
(14)
-
pan
(10)
-
protective ring
(13)
To Next Page
Loading...
