Entris
®
BCE Operating Instructions 25
System Settings
Parameter Setting values Explanation
DEC.PLCS NONE The result of the “Calculation” application is displayed without decimal places.
1 DEC.PL.* The result of the “Calculation” application is displayed to 1 decimal place.
2 DEC.PL. The result of the “Calculation” application is displayed to 2 decimal places.
3 DEC.PL. The result of the “Calculation” application is displayed to 3 decimal places.
* Factory setting
7.3.16 “APPLIC.”/”DENSITY” Menu
Parameter Setting values Explanation
DEC.PLCS NONE The result of the “Density determination” application is displayed without decimal places.
1 DEC.PL.* The result of the “Density determination” application is displayed to 1 decimal place.
2 DEC.PL. The result of the “Density determination” application is displayed to 2 decimal places.
3 DEC.PL. The result of the “Density determination” application is displayed to 3 decimal places.
* Factory setting
7.3.17 “APPLIC.”/”STATIST.” Menu
Parameter Setting values Explanation
PRT.COMP. OFF Deactivates the component printout.
ON* Activates the component printout.
TAR.STAT. OFF* Deactivates automatic taring after the components are saved.
ON Activates automatic taring after the components are saved.
* Factory setting
7.3.18 “APPLIC.”/”PEAK.HLD.” Menu
Parameter Setting values Explanation
APPLY AT STAB.* Peak values are applied when there is stability.
W/O STB. Peak values are applied without stability.
* Factory setting
7.3.19 “APPLIC.”/”CHECK.WG.” Menu
Parameter Setting values Explanation
INPUT MANUAL* The min/max limits are entered manually.
WG.VALUE The entry of the min/max limits is carried out by applying the weight value.
AUTO.PRT. OFF* The automatic printing is switched off.
ON With automatic printing, all values are exported.
OK ONLY With automatic printing, only values that are within the control range are exported.
NOT OK With automatic printing, only values that are outside the control range are exported.
* Factory setting
To Next Page
Loading...
Need help?
General