Data ID Codes
This function is only available for Combics 2.
You can assign codes (such as product name, batch number, etc.) for identification
of measured values on printouts.
Features – Assign up to six ID codes.
– Assign both a name and a value to each ID code.
– Displaying individual IDs: press the d key
– The name is left-justified and the value is right-justified on the printout.
If the entire code is too long for one line, additional lines are printed.
– Enter ID code names in the Setup menu under:
SETUP / PRTPROT , menu item 7.4.
The name can have a max. of 20 characters.
– Enter up to 40 characters for the value of the ID code. Press the d key to
activate the input mode.
– Individual characters of the ID can be deleted using the c key.
– If both the name and value fields are empty, no ID code is printed.
– In the Setup program, you can configure when and whether ID codes are printed
(see “Configuring Printouts" page 96).
Settings for individual ID codes
Menu: SETUP / PRINT/PROTOC. / HEADlin.
Factory settings for ID code names:
ID1: ID1
ID2: ID2
ID3: ID3
ID4: ID4
ID5: ID5
ID6: ID6
There are no factory settings for ID code values.
Operating Instructions Combics Indicators 51
Operation
To Next Page
Loading...
