Sartorius Genius Series - Statistics Application; Statistics Preparation and Functions

Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
Cal soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to Another Application
● Press d
> See the section on the corresponding
application program for further
instructions
Setup (Setting Parameters)
● Press s
> See “Configuring the Balance” for
further instructions
Turning Off the Balance
● Press e
> The balance shuts off
> The display goes blank, then OFF or
Standby is displayed with backlighting
102
Preparation
● Turn on the balance: press e
> The Sartorius logo is displayed
● Select the Statistics application in the Setup menu: press s
● Select
Application parameters: press the q soft key 2 x,
then the
O soft key once
● Select
Application 3 (data records):
press the
q soft key 2 x, then the O soft key once
● Select
Statistics: press the Q or the q soft key
● Select
Statistics: press the O soft key
Statistics Automatic
ο Off
storage On, first value at stability
On, last value at stability
On, value bet. 70 – 130% at stabil.
Minimum load for None
automatic storage:
ο 10 digits
20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
Source of data for
ο Application 1
auto storage Application 2
Evaluated values
ο Net
Calculated
Net + calculated
Evaluation mode,
ο Intermediate evaluation, print
MR function Final evaluation, print
Intermediate evaluation, display+print
Final evaluation, display+print
M+/M– function,
ο Off
then tare On
Printout of individual No
components
ο Yes
ο = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled
“Configuring the Balance”
● Save settings and exit the Setup menu: press the
oo soft key
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com