8
Press the ON/OFF key
(3)
to turn the display on or off.
You can also turn it on with the tare control
(5)
.
After the balance has been plugged into the AC adapter, the
weight display will go out whenever you turn oft the power with
the ON/OFF key. All other electronic circuits will remain ener-
gized (indicated by STANDBY). This means the balance is im-
mediately ready to operate without requiring warmup the next
time you switch it on.
After the power is turned on, a test of all essential electronic
functions is run automatically.
This self-test ends with the readout 0.00 g (it the program code
setting 511 is used).
Now place your sample or object on the pan
(1)
to determine
the weight. Read oft the weight in the display
(2)
as soon as the
weight unit (in this case "g") appears as the stability symbol.
lf you wish to use a Container to weigh, or if the weight display
does not indicate 0.00 g (or the equivalent with the weight unit
of your choice), press the tare control to zero the display.
To Next Page
Loading...
Need help?
General
